[ZX6R2011]

Found a screw with my rear tire getting the tire fixed now and need to know the torque specs for the rear axle nut. 2011 ZX6R.

And another question under the same regard. When reassembling do I have to use some sort of lube on the axle and spacers? Any tips are appreciated

 

[BM2]

93.7 ft lbs

 

[ZX6R2011]

Thanks, I appreciate the help.

 

[RockerPhotog]

stop at 94 ft/lb then tighten until the hole clears for the pin, shouldn't be much btw.

 

[ZX6R2011]

Thanks, I had been thinking it was somewhere around there. But wanted to be sure.

 

[whocanitBnow]

As far as lube goes for the axle shaft. I've always just dab some grease on the shaft before sliding it thru. Couldn't hurt since you already have it off. :O

 

[MistressOfMayhem]

I usually spray it down with some White Lithium Grease. I've never had a problem.

Also: You might find it beneficial to download the service manual. You can find it here: http://zx6r.com/service-manuals/12596-2009-2010-2011-kawasaki-zx-6r-service-manual.html

 

[BM2]

Fuck it you should just come over and have a few beers i'll help out