Kawasaki Ninja ZX-6R Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
986 Posts
Discussion Starter · #1 ·
Hey guys, I running all four boxes and wiring harnesses for my Halos and Bi-Xenon Mini H1 Projectors. So I'm going to need the room where the servo is. I've already removed the wires, so it's still hooked up, I just need the room.


So I'm looking to guy a servo buddy or servo eliminator plug for my 2014 6R. I just can't seem to justify buying some resistors, farad cap, etc... that takes 10 minutes to do for over $56 + actual shipping will land me in the mid to high $60's.

Any other options out there for me that won't be the same size as the servo motor itself?

Thanks!
 

·
Registered
Joined
·
108 Posts
Hey guys, I running all four boxes and wiring harnesses for my Halos and Bi-Xenon Mini H1 Projectors. So I'm going to need the room where the servo is. I've already removed the wires, so it's still hooked up, I just need the room.


So I'm looking to guy a servo buddy or servo eliminator plug for my 2014 6R. I just can't seem to justify buying some resistors, farad cap, etc... that takes 10 minutes to do for over $56 + actual shipping will land me in the mid to high $60's.

Any other options out there for me that won't be the same size as the servo motor itself?

Thanks!

+1 need one myself 13' tried making it but the circuits on some of the displayed diagrams aren't complete so after first which works fine turn off bike, second time light comes on.
 

·
Registered
Joined
·
986 Posts
Discussion Starter · #3 ·
Guy I found on this message board was selling them. He doesn't have anymore. He said he might make some more later, but not anytime soon.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top