[Scumbag]

I’d explained that in your introduction post.
What he did was removed the reservoir from the rear plumbed in a line to the front hand brake as you figured out lol

Like you said all you need to do is remove that line and lever and move the reservoir back to the rear. All you need is the black connector but it’s probably still hooked up somewhere on your bars where he added the hand brake. Post a pic of how he plumbed that end . That’s the most common hack way that guys do it anyways. Either way worse case you just need that elbo

 

[Scumbag]

But there is your fitting you need lol

 

[Scumbag]

I’m sure they do. Can’t recall a company right off but I know drag sells billet ones. You can also just stick that t and about 6 inches of line and fill it and plug the top and not even run one till ya can get one. Seen a lot of guys never even run one. You’re only pushing like a table spoon of oil each time.

 

[Scumbag]

Yea. That links weird. Goes to the reservoir but says and shows all those levers and stuff.
But all you need is a bottom fed reservoir and bolt it on.

 

[Scumbag]

Looks right to me.