Kawasaki Ninja ZX-6R Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hi i have a 95 zx6r stock so far. I had a bad motor i took out to replace with a new 02 zx6r motor. It had spark before i took the old motor out. While motor was out it got knocked out and hit hard on the left side. When i put the newer motor in it had no spark. So far i ohm tested plug caps wire coils stator and pick up coil, all those were to spec. Battery is good and im getting fuel, im told the cdi cant be tested and i dont know how to check the ignition, killswitch, and regulator. Both safety switched are good. All grounds are good. Also i get a spark once in a while but only one spark either when i first hit the start button or when i let go of it. I am mechanicly inclined, just lost in what else to do. I have a multimeter an test light. Any help would be very nice, or if anyone has ever done this swap please tell me if i did something wrong or missed something please and thank u!!!
 
1 - 1 of 1 Posts
Top