Kawasaki Ninja ZX-6R Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,008 Posts
Discussion Starter #1
I remember a stand thread that someone mentioned the moto-d stands and I was wondering If anyone owned a set and could compare them to the cheap harbor freight stands? They look like harbor freights but painted black and I was wondering on the quality....
 

·
Registered
Joined
·
1,008 Posts
Discussion Starter #3
I like the low profile aluminum style stands but hf's were very thin aluminum and even shittier welds
 

·
Registered
Joined
·
442 Posts
I currently have a set of MOTO-D stands and like them a lot. HOWEVER, I am not fond of the front stand and very recently have made the leap to Pitbull stands. I have read over and over about "quality" and holy crap...the quality is over kill. The Moto-D were good...but there is no comparison to the Pitbulls. Back to your org question...I have a HF stand also as a back up from years ago. It doesn't get used much, but the Moto-D is slightly better...as far as craftsmanship goes IMO.
 

·
Registered
Joined
·
865 Posts
The HF doesn't fit my 2014 636 but I have used it on my 650 for the past 5 years and it still looks new. If the moto-d are better, they should last you forever. I use the MJ Moto head lift set for the 636.
 
1 - 6 of 6 Posts
Top