Kawasaki Ninja ZX-6R Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
127 Posts
Discussion Starter #1
Hi all, just joined and need some advice. Ive been in the process of striping my G2(1999) ZX6R for the last few months and everything is great bar one thing! Stupid as it sounds as ive done everything from suspension, swingarm removal, wheel bearings… etc. But i have a new rental front sprocket to go on and i cant remember which way round i should install it. A pic from on of you guys would be a great help. Thanks in advance and all the best. The ginger ninja.
 

·
Registered
Joined
·
316 Posts
There should be an " OUT " mark on the sprocket,this should be facing you when replacing it on the shaft.Replace the locking washer with a new one as well.
 

·
Registered
Joined
·
617 Posts
Get your hands on a shop service manual(if you don't already have one)they are an absolute life saver when performing your own maintenece.
 

·
Registered
Joined
·
1,927 Posts

·
Registered
Joined
·
127 Posts
Discussion Starter #5
Cheers guys, its all sorted, once its back together i'll post a few pics… i must say its going to look mint! Thanks again.
 
1 - 5 of 5 Posts
Top