Is your battery fully charged and reading over 12.5v when the bike is not running?

Did you have a dead battery while your ecu was out getting flashed?

It is likey to just be the ECU was "powered down" and it thinks it has a low voltage sitution and it would go away after hooked back up to a fully charged system and everything working properly then being ridden more than a few miles...

but you could count the flashes and look up the error code, but I have seen a few do this upon return from flashes and they went away in short order....


Make sure your battery is fully charged then go for a ride, it should shut itself off and reset, if it does not do it in say 5 miles, pull over, turn off ignition wait 5 minutes and re-start the bike and ride again.......
if after that it stays on something else is the problem

 

I rode it for probably a hour or so yesterday, no changes, the yellow ! Stays solid and the KIBS flashes non stop. I also disconnected the battery for an hour and tried that still no luck. I am going to go put it on the charger now, even that says it's at 100% though.

I'm at a loss...

 

Did you got finally sorted I have this problem now

 

I also have this problem now, do u solved?