Kawasaki Ninja ZX-6R Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3,588 Posts
Discussion Starter #1
Ok, so I have a few questions. I have a 1996 ZX6F (ZX6R), and I ran into a problem trying to take out my carburetor. The bolts that hold it in place (I think) are very tight and don't budge, and I could only actually put my allen wrench on one of them. the rest are very hard to reach and very deep. These are what I need to take out right??? It will be put away for the winter shortly, so I figured this would be the best time to clean and possibly re-jet the carbs. Another unrelated question... Where can I find frame sliders for my bike, and where do they go? I was reading up that the uncut ones need the coolant over-flow bottle removed and replaces with a new one with a hole in it in order to fit the slider? Is that right, and where can I send mine to get that done?
 
1 - 1 of 1 Posts
Top