Kawasaki Ninja ZX-6R Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8,339 Posts
Isn't it just like every other electrical connector of its type.........

slide thin tool in slot
it depresses a tab
you slide the connector out of the plastic housing


look in there with a flashlight.... a magnifying glass if you need (old and waining eyesight?)
 

·
Registered
Joined
·
8,339 Posts
I honestly didn’t have the heart to discuss this one.
yep..... seeing the low quality of work on those butt connectors and knowing the space limitations and likelihood of numerous issues.............


OP

isn't that just an isolated front harness that can be replaced for sub $100........?

why not just replace it?? pretty sure this is it..........



HARNESS,FR
26030-1779
$85.82
 
  • Like
Reactions: RJ2112

·
Registered
Joined
·
8,339 Posts
Those small square/rectangular holes under the actual connector plug ins.......... those are the release mechanism

so yes this connector is just like every other connector of the type I have ever seen.........

It is a you problem not a some special never before seen connector problem

and like RJ said, sometimes you need to push the actual connector slightly in to the body then depress that lock tab on the connector then slide the connector out of the body

there are a couple of special tools available made just for this, but I have found some welding tip cleaners or even a ground down super small screwdriver to work just as good and sometimes better
 
  • Like
Reactions: RJ2112
1 - 3 of 3 Posts
Top