Kawasaki Ninja ZX-6R Forum banner

wiring

  1. The ZX6R
    I have 06 zx6r and the blinkers will not work It does not light up on my dash at all to tell me that they are working and my tail light lights up but when I hit my brakes it does not light up brighter to tell the people I’m breaking behind me please help thanks
  2. Mechanical and Technical
    So i bought an 05 ZX6R from a guy who turned it to a stunt bike. I am in the process of bringing it back to "Stock" and cant seem to find what wires are for blinkers and brake light. If anyone has a better diagram then ive found onliine it would be a huge help! Picture too of course are great...
  3. Mechanical and Technical
    Hey all, I recently ripped apart the bike to do routine maintenance and discovered that the previous owner had wired the fuel pump in a weird way. The black and yellow wire is missing from the back of the male connector on the bike. In the wiring diagram, this looks like a ground wire. While...
  4. Mechanical and Technical
    So i have a 04 636 frame with a ZX600KE motor, my issue began with a stick coil going bad and thought that would be the end of it, popped a new one in, made it 15 miles away and the new one exploded, since then ive been through roughlllllly 5 stick coils in the time span of about 1 month...
  5. Mechanical and Technical
    Can someone please help me with removing the speedo cluster from a 2002 j3 636 and allow the bike to still run. Putting the engine in a quad bike and am not running the dash cluster and cannot figure out how to wire it up so it runs. All help appreciated :)
  6. The ZX6R
    Can anyone provide a wiring diagram for a 2007 zx6r horn schematic? My horn fuse keeps blowing. Works for a little while then after a ride or two it blows. Couldn't find any diagrams so if anyone had one or has had this issue would appreciate tips!
  7. Mechanical and Technical
    Hey everyone i recently bought a 99 zx6r (g) for a cheap price that was involved in an accident. It bent the front forks bent the radiator and broke the clutch foot peg i removed the damage plastics, gas tank, and seats then went front to back inspecting the wiring. Out of all of it i found two...
  8. The ZX6R
    This is a new to me 06 636. The tail light is an integrated unit and the turn signals worked fine, but the brake light did not. I've since pulled it off the bike to rewire it properly, but I thought I'd share what I was working with. I'm also a newb at electrical work so I'll probably have a...
  9. Mechanical and Technical
    So my fan won't cut on, even when the temp gets over 230°F. I unplugged the fan and hooked it up to the battery, fan comes on and works great. So i eliminated that. I checked the fuse for the fan, that's good. So i eliminated that. What now?! Everyone says check the relay but i dont know what...
  10. Mechanical and Technical
    Hello all, I have been trying to convert my 04 Ninja 636 into a street fighter. I purchased the dual domanator headlight which is 2 H4 lamps so both are low and high beam compared to the stock one for low one for high. The problem is that when I turn on my high beams it blows the fuse for my...
  11. The ZX6R
    Just traded a car for a 2006 Kawasaki 636, I knew it had a some small problems, fairing hardware replaced with self tapping screws, a rear brake pad that was practically gone and no headlight bulbs. Also a few cracks and dings from either a failed wheely or a highside. Runs great, sounds good...
  12. Mechanical and Technical
    Hello all, first time posting here, but hoping to become much more familiar with the site! Looks awesome. Anyway, I have a bit of a problem right now and I've been searching for an answer to no avail.. I've got a 2009 ZX-6R. I was in an accident a few months ago and I've slowly been rebuilding...
  13. Mechanical and Technical
    Hello All! I'm looking for a wiring map/diagram/schematics for my 2012 ZX6R. I'm trying to install an SDC Backoff Brake Hold Module, but it is quite hard without knowing where the wires are that I need to connect to it. If anyone has or knows where I can find the wiring information please let me...
  14. Mechanical and Technical
    How do you trace the start kill switch it Is unscrewed it off my clip on after a wreck and need to unplug it from my 09 ninja 6r non monster engine harness it appears to go deep into the engine to unplug it, my right fairing is off aswell ass my tank is propped up.. I can't seem to find out how...
  15. Mechanical and Technical
    Just installed a fender eliminator kit. Blinkers work. Tail light and license plate light work only when the key is turned all the way to the right in park. They don't work when the bike is running and neither does the brake light. The brake light doesn't work no matter what position the...
  16. Mechanical and Technical
    Just picked up an 06 636 special edition, going through the bike I have found that I have rear turn signals but no brake light or running light, it's an after market set up and a cluster of wires back there! Anyone know where I can get a diagram or some help?
  17. Mechanical and Technical
    Ok guys, I need help with an electrical problem that I have created for myself. I am a complete doughnut when it comes to electrical, obviously, so I am hoping there are a few sparkys out there that can help out. I have an 05 636 that I am building as a track bike, and its just about complete...
  18. Mechanical and Technical
    How is everyone tonight? It's finally my Friday and it's been a long week. Doing a little relaxing now. Anyways I have this problem... So this is what's undertail for my tail light wiring (and some other stuff...?) You have a plug with two prongs which are a red wire and a blue/black(maybe...
Top