Kawasaki Ninja ZX-6R Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. Mechanical and Technical
    Hello everyone,I’m having trouble i just swapped the motor and switched the oil out with 10w -40 mobile racing t. i ran the bike for 10 min turned the bike off and back on but the red light is still blinking and has the symbol of low oil. I did put the correct amount as suggested. Please help.!!
  2. Mechanical and Technical
    Battery Fully Charged So yesterday I decided to take the bike out and run some errands. I was riding literally all day, shopped at a few places Overall turned the bike off and on multiple times yesterday. The problem started at my last stop of the night, the grocery store. I go in, pick up a...
  3. Mechanical and Technical
    Struggling... How do I disconnect these connectors? They seem stuck
  4. Mechanical and Technical
    Recently dropped the bike and now everytime I start the bike up the fan kicks on immediately even from a cold start , so I’m trying to locate the temperature sensor and diagnose the problem btw checked the bike and has no leaks and is not overheating
  5. Mechanical and Technical
    Hey guys This for a 2019 zx6r: So I installed my pcv yesterday following this video by j&pcycles: Everything seemed straight forward except the throttle sensor. I couldn't find it, but I saw a small plug underneath the left side of the airbox that I thought might fit into the pcv harness and...
  6. Mechanical and Technical
    Okay so, I picked up my ‘08 ZX6R almost a year ago. Had 2200 miles on it when I bought it. Only problem I found on it when I bought it was that the turn signals didn’t work. That wasn’t going to stop me from buying it. I mean, it had 2200 miles and was a steal, COME ON! Anyway, whenever I would...
  7. Mechanical and Technical
    So recently my 99 ZX6R G2 drop and inlet valve so I've had to rebuild the engine. I have nearly finished the rebuild but i'm having an issue. I have power to the coil but no spark. I also have power to the starter motor but it's not turning over. It is grounded properly and isn't a faulty coil...
  8. Mechanical and Technical
    I have a early production 2013 ZX6R that I bought used. When starting it cold it may take 2-4 attempts until the engine will start warming up instead of dropping rpms too low and stalling out. I have done a lot of research and this appears to be an ECU issue. I have found a good price on a 2015...
  9. Mechanical and Technical
    Hi all :) hopefull someone can give me some info about an issue im having. Ive got a G2 zx6r which at idle seems to jump, not alot but bumps from about 1300 to 1500rmp and throttle under load bogs down low to mid range revs. Going from 2nd to 3rd when pulling on throttle losses power and...
  10. Mechanical and Technical
    Hey guys, I have a 08 and recently have been installing a two brothers full system. Everything has been going fine and has fit properly. Once i went to put on the header, I realized that the flanges won't go on because the spacer where the exhaust gasket sits is to big. Everything else seems...
  11. Mechanical and Technical
    I have a 07 zx6r with 10k miles on in I bought it today and I rode it for a while with no problems, but later when I came back to ride I'll start it but when I shift to 1st to take off it stalks out would it be the clutch cable or something worse.
  12. Mechanical and Technical
    My Kawasaki Ninja 636 2005 runs around 208 degrees in F at idle is that normal or should it be lower?? because its get somewhere around 220F when driving?? any advice.. Answers etc?????
1-12 of 12 Results
Top