Kawasaki Ninja ZX-6R Forum banner

stripped

  1. Mechanical and Technical
    Been leaking for the past I'd say 6 months all because I can't remove these bolts! Sick of it! Took the other side off just fine these are the problem. Completely stripped. Went to buy a set of bolt extractor bits and that didn't work either. I've tried hammering the next biggest size in there...
  2. Mechanical and Technical
    So I bought a new sprocket kit and was so excited to put it on. I looked everywhere for the tools I'd need and went and purchased a deep 27mm and 1/2 torque wrench at sears. I already had a breaker bar and about a foot of steel pipe. had my wife help me hold the break down and also used a 2x4...
  3. Mechanical and Technical
    So ive read through most of the threads on here and other forums about how to go about removing the right engine stud, for the purpose of installing sliders. Well after i stripped it (using impact gun btw), i tried the extractor method, and the extractor broke off inside the bolt... ive seen...
  4. Mechanical and Technical
    While doing an oil change on my bike I was screwing the drain plug back into the oil pan/crank case (i'm not super mech inclined) and apparently tightened it too tight. Either the drain plug is stripped (unlikely but possible) or the oil pan where the drain plug screws into is stripped. I've...
Top