Kawasaki Ninja ZX-6R Forum banner

electrical

  1. Mechanical and Technical
    Hey all, I recently ripped apart the bike to do routine maintenance and discovered that the previous owner had wired the fuel pump in a weird way. The black and yellow wire is missing from the back of the male connector on the bike. In the wiring diagram, this looks like a ground wire. While...
  2. Mechanical and Technical
    Hey all, I recently picked up an 07 ZX6R with 3000 miles on it (some guy was letting it rot in his garage) so I did a once over on it replaced fuel oil coolant ETC. and it rode great but about a month ago now when I was taking my old lady for a ride I lost power when I accelerated it had no get...
  3. Mechanical and Technical
    I have a 2003 ZX6R and had a starting/electrical issue. I parked the bike for three days and it was fine before and for an hour when I started riding. I turned the bike off for a break and when I went to start it the bike acted like the battery died so I jumped it and started fine, went to ride...
  4. The ZX6R
    Can anyone provide a wiring diagram for a 2007 zx6r horn schematic? My horn fuse keeps blowing. Works for a little while then after a ride or two it blows. Couldn't find any diagrams so if anyone had one or has had this issue would appreciate tips!
  5. Mechanical and Technical
    I recently got this bike, so I am a newbie when comes to many different aspects of the bike. But I changed the oil and oil filter recently. Now the bike when it starts just idles at about 750 rpm then starts going to 500 rpm then dies after about 30 seconds. If I give it a bit of throttle it...
  6. Mechanical and Technical
    hey guise, i just replaced my RR and the new unit ignores the ignition switch. so when i plug it up ... the bikes turns on, then will not turn off unless i unplug the RR or battery. i tested the old RR, and the key works fine. what could the problem be? is it simply a bad RR? thank youuuu
  7. Mechanical and Technical
    Hey there my 93 zx6 has been giving me trouble. At first it was having a rough time starting up on a colder summer morning. At one point I ended up running the battery trying to start it until it couldn't turn the starter. I jumped the battery with a ca it started. I ride for a short period turn...
  8. The ZX6R
    Just traded a car for a 2006 Kawasaki 636, I knew it had a some small problems, fairing hardware replaced with self tapping screws, a rear brake pad that was practically gone and no headlight bulbs. Also a few cracks and dings from either a failed wheely or a highside. Runs great, sounds good...
  9. Mechanical and Technical
    Hello, so I have been experiencing some weird electrical issues with a bike that has rarely given me any problems before. (35k miles, no aftermarket fuel systems) It all started labor day weekend when a buddy and I went on a ride to Sequoia and Kings Canyon national parks. Anyway, I lost both of...
  10. New Member Introductions
    bought a new (to me) 2000 zx6r about a month ago, so far i like it even though its a little bit older than my previous gsxr was, but heres the thing. one morning on my way to class i go to fire it up and nothin happens, lights are dim, starter makes one click and dash is blank, i figure oh well...
  11. New Member Introductions
    Hey all! So I've got a 95 zx6r. Recently did a carb clean and the performance has improved greatly! When I had that done however, it was brought to my attention that the front fairing is only being held by the two ram air ducts that come from the front fairing. That said, the guy that did...
  12. Mechanical and Technical
    Went to DMV today to take my road test only to find out that my brake lights are not working. neither the front nor the back are signaling. the tail light is working just fine. I checked the fuse under the seat and it's intact as well. as far as I can tell the tail light is an led assembly so...
  13. Mechanical and Technical
    Hi everyone Im crap at DIY and mechanical/ electrical stuff and am in desperate need of help. I want to replace my OME tail light on my ZX6r J1 (2001) with an LED one (with integrated turn signals) that i have brought on line. When i went to change it the wires for the tail light, brake light...
  14. Mechanical and Technical
    Hello forum, I currently decided I wanted to rebuild my 04 zx6r from the ground up to have a fully custom bike. Everything was going well until earlier today when I was hooking up the rear tail light. When I plugged it in and turn the bike on they came on right away and brightened when I...
  15. Mechanical and Technical
    :O::thumbdown: Hey everyone, My name is Sarra, I have a 2005 ZX636RR with a dynojet power commander. Recently I bought a new set of fairings. I disconnected the battery, removed all the fairings, and the fuel tank to vinyl it to match. I started reassembling my motorcycle, and I must have...
  16. Mechanical and Technical
    Over the last week I have failed miserably at replacing the taillight on my 07 zx6r. What seemed like a simple procedure of matching up color coded wires has turned into a head pounding catastrophe racking me up a bill of more than 250 dollars. It started when my stock taillight broke off at...
  17. Want to Buy
    I'm looking for a Stator for my 2011. Let me know what you got and how much you want shipped to Canada, postal code: K9A4C1 Thanks
  18. Mechanical and Technical
    Just bought an 08zx6r with 2100 miles. The bike was only warmed up and ridden in a neighborhood since 2010. When i bought it, bike wouldnt start because of faulty fuel pump so i bought a used one on e-bay. Installed it yesterday and the bike started. Took the bike for a ride today and it runs...
  19. Mechanical and Technical
    Just got hold of a 2001 ZX6R and the thing doesn't seem to be charging. It finally warmed up enough to get the bike out of the garage so I fired it up in the driveway and let it warm up. It made it about 8 minutes then died spontaneously. The lights and guages were still working and the you...
  20. Mechanical and Technical
    Hey everyone. Recently I had to take my bike completely apart because the original frame was bent. So of course I tore the bike down to nothing. After an hour of taking things apart I finally got the new frame in and every bolted to it (swing arm, forks, engine). I knew I would have major...
Top