Kawasaki Ninja ZX-6R Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 32 Results
  1. Mechanical and Technical
    2021 zx6r 636 14,xxx miles. Just ordered the ftecu bike side harness. The instructions said to alter 3 pins at the ecu connector. Reading the diagram wrong, I accidentally altered the 3 wires on the exact opposite side of the plug thinking that the diagram they showed was at the front of the...
    ecu
  2. The ZX6R
    Hi, I just bought an akrapovic full exhaust. Do you guys recommend getting a power commander or have my ECU sent it? Thanks for your help
  3. Want to Buy ISO 2006 636 ECU

    Want to Buy
    Looking for an ECU for a '06 636. I'm about 80% sure the ECU in my '05 is completely boned as the last time I rode it during the summer, the bike bucked and shut down after ~30-45 minutes of riding. I had already done the relocation, but I think it was too late. I'm also going to try and find...
    $200 USD
  4. New Member Introductions
    I had my ECU flashed by a guy in Florida, he adjusted the fan temperature, the fuel curve, throttle in all gears, but when I put the bike on the dyno it still has the same horspe power than before (132) and the AFR went from 12.4 to 11.9. However the top speed improved a little bit. Is it normal ?
  5. The ZX6R
    Anyone have a part number /!know where I can find this connector?? Off a 2019 zx6r for the ecu.
  6. Member Classifieds
    I have a flashed ecu by Schnitz Racing off my 2017 zx6r that was stolen. It has 2,400 miles on it. Flashed for the following: M4 Slip-on Disable Exhaust Valve Servo Motor Disable Pair Valve It also has other items address which can be seen in the photo by Schnitz Racing. $220 OBO
  7. The ZX6R
    So I just got an 05 636 and had a shop look over everything and they said all was fine. So I went for a ride today and after about 1.5 - 2 hours she started to big down pretty bad and it throws a code. I let it sit for a little and it cooled down and rode fine. Do I need to heat shield under the...
  8. New Member Introductions
    Hey guys, I just recently joined the forums, and feel quite a bit encouraged with the wealth of knowledge on here. First things first, I tried doing some searching on the forums for the answer I’m seeking, but didn’t really fully get it. Let me start from the beginning: Last month I purchased...
  9. Mechanical and Technical
    Hi all, My story begins with a periodic service (42,000 Km) I needed to do to my 2013's ZX6R. The service included: * Replacing all 4 spark plugs * Cleaning air filter * Valve clearance * Replacing steering stem bearings * Replacing oil+filter * Set of new tires Since the bike wasn't running...
  10. Mechanical and Technical
    okey so after i experienced the dreaded ECU issue on my 2005 ninja 636 i eventually found out it needed changing. so i bought a second hand one from eBay believing its a simple plug in and play procedure, however the day has come to fit it and now the bike wont start with the new ECU- when i...
  11. The ZX6R
    A while ago, i bought the usb harness and sw license from FTecu.com to get rid of the error code after removing the exhaust servo, disable fuel cut on decel (which made the transition from off to on throttle MUCH smoother btw.), set fan temp etc. It did the job. Recently I took my bike (2013...
  12. Mechanical and Technical
    Hi All, I believe I have the dreaded 05 636 ECU issue. I can ride my bike for 30mins to an hour at normal riding speeds before it starts to sputter and eventually die on me. I can let it sit for a minuet or two and it will start back up. If I'm on side streets and I start it back up it will...
  13. Mechanical and Technical
    Hey all, New here and to riding in general. Just purchased my first ebike ever! 05 zx600rr! Went through all the motions of to start on a 600 or not, ended up with a 600 nd I couldn't be happier! That said... One thing that could make me happier is solving this issue I'm having.. I've read about...
  14. Mechanical and Technical
    Ok so just bought my 2006 636 and left it in my garage for a week. The battery was completely dead and had no fluid left so bought new battery. A week later same thing completely flat. there is no alarm or any accessories on the bike. I checked to see how much draw/current with ignition off and...
  15. Mechanical and Technical
    okay so i was riding yesterday on the freeway, i dropped down to 5th to get around someone, gave it some gas and it sounded like my bike transformed into a dirtbike. FI light came on, i got it off the freeway and parked. I put it in to dealer mode 1 and got a code of 54 which is coil pack #4...
  16. The ZX6R
    I am going to wrap my exhaust soon, but the mid pipe has a heat shield on it, so should I take it off somehow (it's welded or rivited on) and wrap just the pipe, or wrap the exhaust and heat shield together? P.Sz I would like to get aftermarket headers and a mid pipe that will increase the...
  17. Mechanical and Technical
    So I just bought a 2007 zx6r 600, my first bike. The problem I'm having is the bikes speedo isn't working. The gauge lights up but dose not display any information including gears,speed, and RPM. Here's the real kicker though, before you ask have a checked the cables, yes, yes I have. I took the...
  18. The ZX6R
    So I just bought a 2007 zx6r 600, my first bike. The problem I'm having is the bikes speedo isn't working. The gauge lights up but dose not display any information including gears,speed, and RPM. Here's the real kicker though, before you ask have a checked the cables, yes, yes I have. I took...
  19. Mechanical and Technical
    UGGGG.....Hi guys, lifetime GSXR guy, literally bought my first Kawi 3 days ago. Beautiful bike, probably the nicest feeling bike i've ever gotten to ride. The intput, agility, nimbleness and aggressiveness are...WOW... but THIS!!!!! here is a brief summary of my experience thus far on the 05...
  20. The ZX6R
    I just wanted to post a quick positive review regarding my 2013 zx6r's ECU flash. THIS IS FOR A TRACK BIKE! I was hesitant to send in the ECU to Schnitz Racing due to other posts negative reviews because of the 75 dollar price. So I called Schnitz and they answered all of my questions regarding...
1-20 of 32 Results
Top