Kawasaki Ninja ZX-6R Forum banner

clutch cable

  1. Mechanical and Technical
    Hi All, I've attached 2 photos that better describe this problem. My clutch cable snapped and I was trying to replace it, when I accidentally removed this (rod?) by pulling it upwards. It inserts into the engine vertically. I put it back in, but as I try to hook up my clutch cable, I notice...
  2. Mechanical and Technical
    Hey guys, before we get started, no this isn't a thread asking if its bad to shift without the clutch, the point of it, if it will help me hit mach 4, or if you recommend it. Did my due diligence and searched, but only found threads that talked about the things I just listed. Mad Scientist Moto...
  3. Mechanical and Technical
    so about a month ago I had a low side on my left end. it was very mild with minor road rash on the bike and my left side footrests and gear shift were broken. I replaced the rear set within a week and have yet to fix the cutting out of the engine while trying to get into 1st or 2nd gear...
  4. Mechanical and Technical
    Recently purchased a 2009 zx6r and the clutch cable started to fray and the handle. This being my first bike I'm not too sure how to replace it myself. I looked at the owners manual and it says to replace remove the air cleaning housing and the right fairing. To remove the air cleaning...
  5. Mechanical and Technical
    hello all its been a while! need some help. i discovered after a fair few miles that the clutch cable was fraying at the lever end. so i replaced it. seemed simple enough to fit, and the cable also looks good quality. i bought it from a respectable bike shop. but now after a fraction of...
  6. New Member Introductions
    Hey all, Finally got on a forum! I bought my 1995 zx6r this past spring with only 7k miles on her! She runs great, honestly keeps up about dead even with my buddies R6! If anyones got suggestions as to what i should do first let me know! This week i am replacing a snapped clutch cable...
  7. Mechanical and Technical
    hey whats up guys, ive got an '08 ZX6R. been having an issue with the clutch cable becoming progressively looser. just looking for some advice..is this a common problem? or am i just dealing with a touchy cable...? thanks guys, also, what are your recommendations for HIDs?!!! i appreciate your help.
Top