Kawasaki Ninja ZX-6R Forum banner

1995

  1. Mechanical and Technical
    Hey guys, I just picked up a 95 zx6r and am in need of a new or used clutch push rod. ROD, CLUTCH Part Number: 46102-1371 Previous owner lost it.. its the small pin that goes in the middle of all the clutch discs. I’m struggling to find any info on if a rod from a newer bike may work. It’s an...
  2. Mechanical and Technical
    Hi there. Anyone else got an F1-F3? Mine is taking a bit of work, lots of parts wearing out. Unsurprising for a 22 year old bike. If you've got one of these bikes, I can use all the advice I can get. I've just replaced the clutch plates, and noticed my throttle grip was very stiff. Turned out...
  3. Service Manuals
    i have a 95 zx6E and im needing a manual to help me fix it. any help would be appreciated thank you!
  4. The ZX6R
    Hello everyone, I changed the stock front and rear turn signals on my 95 zx6r F model to LEDs. They blinked way to fast and after reading forums, I realized I needed to replace the relay with a new electronic LED flasher relay. Did that. Now they blink at the right rate, but all the blinkers...
  5. The ZX6R
    To any one who can help me out... I have a 1995 zx6. I was out riding one day, after about 30mins of riding i noticed my resrvoir tank started overflowing causing it too shoot out hot coolant from the weep hole. I immediately pulled over and noticed the fan was on and my temp gauge needle was...
  6. Mechanical and Technical
    Hi all I have a 95 F1 and when changing the spark plugs noticed the caps need replacing too. Does anyone know of an aftermarket part and where to get them rather than pay the $50ea for genuine? Cheers Brett
  7. Mechanical and Technical
    Hey guys my other issue is my starter. I've also found a few threads on this that did not quite answer my questions. Basically since last spring the starter has been kind of moody. It was having trouble starting every so often maybe once or twice a week it would give me trouble. This...
  8. Mechanical and Technical
    While doing an oil change on my bike I was screwing the drain plug back into the oil pan/crank case (i'm not super mech inclined) and apparently tightened it too tight. Either the drain plug is stripped (unlikely but possible) or the oil pan where the drain plug screws into is stripped. I've...
  9. New Member Introductions
    Hey all, Finally got on a forum! I bought my 1995 zx6r this past spring with only 7k miles on her! She runs great, honestly keeps up about dead even with my buddies R6! If anyones got suggestions as to what i should do first let me know! This week i am replacing a snapped clutch cable...
Top